ET-FC01 Fingerprint Car Alarm lock, It's the best choice for car security.
Products introduction
1. Host--Master control unit of alarm system
2. enroller--place where fingerprint is placed for enrollment or to start car
3. Password Controller--enter pass code, change pass code, enter or delete fingerprints,
"valet mode" setting, optional settings--all controlled by this numeric key pad
4. Speaker--Alarm give you instructions on settings for options or fingerprint enrollment
5. Plug end of fingerprint enroller and password controller
6. Steering Wire--alarm wire harness
7. Power Wire Inert--Connector end of wire harness to connect alarm
8. Power Wire--fused wire harness
9. Fuse
 

All plugs mount securely into master control unit. All components are mounted to car, as
the Password Controller can change any of the settings. Do not keep this in the car. Bring
it with you to your car dealer when the car is serviced, so you can place alarm into "valet
mode" so the mechanics can work on your car. When they are done, use the Password
Controller to place the alarm back into the normal operating mode. This Password
Controller is also used to enroll or delete up to 9 separate fingerprints into the system,
divided into 3 groups

Parameters:
description capability index
FAR <0.001%
FRR (fingerprint refuse rate) <1%
fingerprint capacity 3 groups , total 9pcs third in first gourp is anti-robber???
FIS(fingerprint identification speed) <1s
fingerprint collector anti-ESD index ESD 15K air ;8KV(contact)
fringerprint collector life >1.000.000 times
peripheral equipment action speed <2s(adjust)
voice file 30 paragraph
relay max electric capacity 40A
operation temperature -40 -85
work humidity 30%-90%
storage temperature -40 ~125
work volt 8-15V
dynamic current <20mA
static current <10mA
instant starting current <400mA
risit shake capability 10Hz